Page 4 of 6
DNA
Climber w/Ropes
DNA Climber w/Ropes
461R
27JAN20
Rev. G
STEP 4
THREAD ROPE-TWISTED ARCH ONTO CLIMBER
4c. Continue threading the rope-twisted arch, one section at a time, through the rungs;
tighten the rope-twisted arch, at each section, before securing with set screws.
4a. Begin at one end of the climber and thread the rope-twisted arch into the fi rst sphere
approximately 4", OR, until you feel the rope-twisted arch bottom out inside the
sphere.
4b. Secure the rope-twisted arch with PN 104285; set screw should come in contact with
the rope end ferrule. IF, the set screw comes in contact with the "rope", then use PN
104073.
Note: This applies ONLY to the four (4) ends of the climber.
