www.mirabelleproducts.com
© 2017 Ferguson Enterprises, Inc. 0817 502911
IMPORTANT INSTRUCTIONS
- Read before you begin
Read all instructions carefully before beginning installation. Remove the sink from its original carton and inspect it for damage. Return the sink to its
protective carton until you are ready to place it into position in the countertop. Inspect your faucet hardware to insure that all components exist for a
successful installation as outlined in the faucet and/or hardware installation guide. Inspect the waste and supply lines and replace if necessary.
Mirabelle Acrylic Laundry Sink
Installation Instructions
SELF RIMMING INSTALLATION
1. Position the sink UPSIDE DOWN in the desired location on the countertop. Verify the position and
desired fit while observing the front overhang that exists on all countertops.
2. With a pencil, trace a line (or apply a border of masking tape) around the outside edge of the sink on the
counter top.
3. Remove the sink from the countertop.
4. Measure in 3/4” and draw new lines inside the first sink outline just drawn (or taped).
5. Drill a pilot hole inside the line drawn in Step 4 to allow a starting point for the Jig saw.
6. Following the line drawn in Step 4, carefully cut out the countertop.
7. Temporarily position the sink in the countertop opening so the sink edges line up with the pencil line or
tape border to insure a successful fit.
8. Carefully remove the sink and clean the countertop and remove tape (if any).
9. Mount the faucet hardware on the sink following the manufacturer’s instructions.
10. Install the drain in accordance with the manufacturers instructions using Plumbers Putty following the
manufacturer’s instructions. Note: Silicone Sealant or any other sealants other than Plumbers Putty should
not be used as a replacement for Plumbers Putty. Apply a thin, continuous bead of 100% silicone sealant
to the underside outer perimeter of sink approximately 1/4” inside the perimeter and carefully position
the sink in the opening. Remember that the sink rests on a layer of silicone sealant, not dry fitted to the
countertop.
11. Verify that the sink has not moved out of position and immediately remove any excess sealant filling any
remaining voids as needed.
12. Allow the sealant to cure at least 1 hour before proceeding.
13. Install the garbage/waste disposer, if applicable, following manufacturer’s instructions.
14. Connect the drain assembly.
15. Connect the faucet supply lines following the faucet manufacturer’s instructions.
16. Carefully turn on the water supply lines, then turn faucet on and check faucet, drain, and drain assembly
for leaks to insure a completed successful installation of your new Mirabelle laundry sink.
Safety Glasses
Jig Saw
Masking Tape
Paper Towels
Channel Locks
Drill
Regular & Phillips
Screwdriver
100% Silicone Sealant
Pencil
Plumbers Putty
Tape Rule
SILICONE
Safety Glasses
Jig Saw
Masking Tape
Paper Towels
Channel Locks
Drill
Regular & Phillips
Screwdriver
100% Silicone Sealant
Pencil
Plumbers Putty
Tape Rule
SILICONE
GASKET
NUT
GASKET
NUT
SILI
CO
NE
GASKET
NUT
GASKET
NUT
SILI
CO
NE
UNDER COUNTER INSTALLATION
When planning to use a Mirabelle laundry sink in an under counter installation please check style and size
before authorizing cutting of the countertop. For under mounting to granite or marble or solid surface
materials, contact your granite-marble-solid surface fabricator for installation requirements and proper
fasteners. Under counter installation kits are available (PFUCCLIP).
FOR CUSTOMER SUPPORT PLEASE CALL: 1-800-221-3379
