6
Installing the Thermostatic Mixer
1.
The thermostatic mixer must be fitted vertically
as illustrated and can only be installed with
rear supply inlets. the supply pipework
must
be connected as follows:
hot to bottom Inlet
•
cold to top Inlet
•
bottom outlet.
•
Important!
this product does not allow for
reversed inlets.
2.
determine the route for the hot and cold supply
pipework.
Hot
Cold
Outlet
4.
loosen the 2 backplate grubscrews with
the 2 mm hexagon key (supplied) and pull
the mixer and concealing plate from the
backplate.
5.
Unscrew the inlet nuts from the backplate.
concealing Plate
backplate
Inlet nuts
6.
Using the backplate as a guide, mark the
positions of the fixing holes and the pipe
centres.
Note!
make sure that the backplate is the
correct way up (refer to illustration).
large boss
must
be
fitted at the bottom
