6
Terminate the Sensor
The Captis Power+ is provided with 24 terminals, 12 on each side of the device. These terminals can
be connected to one or many different peripheral devices at one time. Use the diagram below to
determine how to wire the connections between the Captis Power+ terminals and the sensor.
Test Sensor
Test the sensor by ensuring there is known data out of the sensor into the Captis device sensor input.
Wake the device and review the data stream.
Test Connectivity
Use the magnet provided to ‘Wake’ the Captis Power+ by holding it over the symbol.
The device should then connect to your platform.
Ensure that the device is tested in its final install location to prove that there is adequate signal
strength.
If the device does not connect to your platform, please refer to the Troubleshooting section below.
WAKE
Summary of Contents for Captis Power+
Page 1: ...1...