7
GB/IE/NI
Safety information / Installation
Safety information
DANGER TO
LIFE AND RISK OF ACCIDENTS
FOR INFANTS AND CHILDREN!
Never leave children unattended with the pack-
aging material. Danger of suffocation. Keep this
product well away from children. This product
is not a toy.
BEWARE OF ELECTRIC SHOCK!
Leaking or water discharge can lead
to life-threatening danger due to
electric shock. Carefully check that all connec-
tions are watertight. Also ensure that all wires
of electric appliances are correct and have
been securely installed.
CAUTION! RISK OF INJURY!
Please ensure
that no parts are damaged and that all parts
are correctly assembled. Incorrect assembly
could lead to injury. Please note that washers
and gaskets are wear parts and therefore will
need to be replaced from time to time. Dam-
aged parts could impact safety and function.
CAUTION!
DAMAGE TO THE ARTICLE!
Please have all installations performed by skilled
individuals.
Be sure all seals are correctly seated.
SCALDING RISK!
When adjusting the hot
water temperature be sure the water tempera-
ture is not too high.
CAUTION!
Be careful not to revere the hot /
cold water plaque
18
. The correct placement is:
left = red (hot),
right = blue (cold).
Please note all seals are wear items and will
therefore need to be replaced over time.
Any leakage or sudden escape of water can
cause considerable damage to buildings and
property. All connections must therefore be
checked carefully to ensure that they are tight.
Familiarise yourself prior to installation with all
local conditions, e.g. water connections and
shut-off device.
The product is only suitable for use in rooms
with a temperature above 0 °C.
Installation
Note:
Familiarise yourself with the product prior to
assembly. Carefully read the following assembly
instructions and safety advice. In the event of incor-
rect installation, all warranty claims – particularly
in relation to subsequent damage – are excluded.
CAUTION!
Before you start installation turn
off the water supply at the mains. Otherwise
injuries and / or property damage may occur.
Connecting the fitting
Note:
this step requires an SW 30 mm open-end
spanner and sealing tape.
Note:
cover any parts which will be screwed with
a damp cloth or plastic clamps. This will prevent
scratches.
Follow these steps:
Wrap sealing tape around the roughened
threaded part (½“ thread) of the S-connectors
1
(see Fig. B1).
Note:
sealing tape not included.
Screw the S-connectors
1
with the sealed
threaded parts into the wall connectors.
Horizontally align the screwed in S-connectors
1
with the spacing guide for the fitting (see
Fig. B2).
Screw the caps
3
hand tight onto the S-con-
nectors
1
to the wall (see Fig. B3).
Insert the seals
4
into the swivel nuts
5
and
screw the fitting body
6
with swivel nuts
5
onto the S-connectors
1
(see Fig. B4‒B5).
Connecting accessories (shower
hose and shower head)
Note:
Shower hose and shower head are not
included in delivery.
Note:
cover each of the parts which are to be
screw connected with a damp cloth or plastic clips.
This will prevent scratches.
Summary of Contents for LED Bath and Shower Mixer Tap
Page 4: ......
