7
GB
Take off the control lever
16
.
Loosen the cartridge end ring
20
by hand, then
screw off the cartridge locking ring
21
by using
a pipe wrench.
Now pull the setting ring
24
upwards with the
help of a screwdriver.
Note:
Do not remove the cartridge.
Place the setting ring in the desired position as
shown in fig. J.
Note:
The setting ring
24
can limit the turning
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
21
onto the
tap body
23
again by using a pipe wrench,
then tighten the cartridge end ring
20
by hand.
Place the control lever
16
back on to the tap
body
23
and tighten the locking screw by turn-
ing it clockwise using a hexagonal key.
Press the red / blue hot / cold label
19
into the
opening.
Turn on the main water supply and check the
temperature limiter.
Eco-Click Function
The cartridge
22
in this tap has an Eco-Click
function. This feature limits the water flow
through the tap. This means you can save up to
50 % water (see fig. K).
Lift the lever
16
until you notice a slight resist-
ance. This resistance will cause a stop in case
of partial opening and will therefore simply
limit the flow of water.
If you want to increase the flow rate, exert
slight pressure on the lever
16
until you
overcome the resistance.
Maintenance and cleaning
Tap care and cleaning
Please note that sanitary fittings require special care
and attention. Therefore you should follow the fol-
lowing advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild detergent
and a soft cloth or leather only.
Screw out the mixer nozzle
17
at regular intervals
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.
Disposal
The packaging is wholly composed of
environmentally friendly materials that can
be disposed of at a local recycling centre.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Information
Potability of mains water
Find out about the potability of your mains water
supply. Your local water authority or water supply
company will be able to inform you.
The following general recommendations
apply to the potability of the water from
your pipework:
Let the water run freely for a short time if it has
been stagnating in the pipework for more than
four hours. Do not use any of this stagnant water
in the preparation of food or for drinking. This
applies particularly as far as babies and infants
are concerned. Failure to observe this advice
may result in risks to health. Fresh water can
be readily distinguished from stagnant as fresh
water is noticeably cooler.
Do not use stagnant water from chromium-plated
pipework for the preparation of food or for drink-
ing or for personal hygiene if you are allergic
