2
www.everik.com
BTH200.KM.072013.IM
1. Charging the headset
The headset comes with a built-in rechargeable battery, prior to using it, it is recommended to charge the battery fully for the first time. When the headset is low
power, the headset emits “Dongdong” tones about every 20 seconds and the red LED flashes. Please recharge the battery of the headset.
How to charge the headset:
Plug USB charging cable into the USB port of computer and connect the micro connector to the headset
It will take about 3 hours to finish charging
Red light on: Charging
Red light off: Finished charging
2. Turning the headset on/off
Functions
Operation
LED indicator
Turning On
Press and hold MFB button for 4 seconds until blue LED flashes
Blue LED on one second
Turning Off
Press and hold MFB button for 4 seconds until red LED flashes
Red LED on one second
Note:
In order to save power, the headset will turn off automatically if no devices are connected after 5 minutes.
3. Pairing the headset
Functions
Operation
LED indicator
Entering pairing mode
Ensure the headset is off, and then press and hold the MFB button for 7 to
8 seconds until red and blue LED flash alternately
Red and blue LED flash alternately
3-1. Pairing the headset—Notes
Prior to using the headset for the first time, you have to pair it with a Bluetooth-enabled device. The pairing procedures may differ pending on the model of the
device you’re trying to pair. Please refer to your device/phone user manual for further information.
The general pairing procedures are as follows:
Keep your headset and phone within 1 meter when pairing;
Start the pairing mode operation on your headset (see #3 pairing headset)
Activate your device Bluetooth function and set your device to search for Bluetooth devices within range and select “BTH200” from the list of devices shown;
Enter PIN/ Password No: “0000”( Note: If the mobile phone supports Bluetooth V2.1, password is not required.)
If prompted by your device to connect, select “Yes”
After successfully connecting, blue LED light on the headset flashes 2/3 times every 4 seconds
Notes:
If pairing failed, please turn off the headset first and then re-pair according to steps 1-6 mentioned above.
After initial pairing, the headset and the device will remember each other, they will no longer need to re-pair next time. The headset can store up to 8 paired devices. When the
number of paired devices exceeds 8, the first one will be replaced.
4. Playing Music
Functions
Status of the headset
LED indicator
Volume up
Playing music
Press + button
Volume down
Playing music
Press - button
Rewind
Playing music
Press
◄
button once
Fast forward
Playing music
Press
►
button once
Pause
Playing music
Press MFB once
Play
Pausing music
Press MFB once
When the headset connects to a mobile phone or Bluetooth transmitter which supports A2DP, you can enjoy music wirelessly through the headset.