4
HEAD AND TANK ASSEMBLY INSTRUCTIONS
Install float and float cage to the head assembly. When installing float, make sure the weighted bolt in the
float faces away from the vacuum head. The float cage snaps on the head assembly and is then secured
using 1/4-20 bolt, washer, and nut provided in the hardware package.
Handle Installation - 16 Gallon Tank Only
Install handle struts to the tank with snap button facing in towards the tank. The screws provided will pass
through struts and screw into the tank’s threaded holes. The washers and nuts, also provided, are fas-
tened on the inside of the tank. When both struts are attached, handle will slide over struts. Make certain
snap buttons lock into holes located on handle.
TO MAKE VACUUM READY FOR USE, FOLLOW THESE STEPS:
1.
Set filter bag assembly in tank.
2.
Set head on top of assembly installed in Step 1 and clamp onto tank with clamps attached
to tank. Make sure head is positioned and centered correctly on tank.
3.
Attach hose to intake connector on front of tank.
4.
Check drain plug to make sure it is securely in place. To make plug larger in diameter, turn
lever on it clockwise: to make it smaller, turn lever in opposite direction.
5.
Attach vacuum cleaner attachment to loose end of hose.
6.
Plug cord into electrical outlet of correct voltage. Push switch to “On” position when ready
to commence work.