Restore default: YES/NO. Color style and video format cannot be restored to factory default
Note: If the address of former remoter is not 1 but another one from 2, 3, 4, the corresponding camera
address will restore to 1 when all parameters or system parameters are restored. User should change the
remoter address to be 1 (press No.1 according to the camera so to get normal operation)
4. Network Connection
4.1 Connecting Mode
Direct connection: Connect the camera via network cable to external Internet access of the PC
Internet connection mode: Connect the camera to Internet by Router or Switch and user can log in the device by
browser
.
Note: Please do not put the power and network cable in places where can be easily touched to prevent
video quality lowered by unstable signal transmission due to poor contact of cables.
The computer must have the network segment where the camera IP address belong to. The device will not be
accessible if without the segment. I.E. The camera default IP address is 192.168.5.163, then segment 5 must be
added in the computer. Specific steps are as below:
Firstly open the window of Local Area Connection Properties on computer, select the “Internet protocol version
4(TCP/IPv4)” as shown by picture on the left. Double click or click the property “Internet” protocol version 4
(TCP/IPv4)to enter into the Internet Protocol Version 4(TCP/IPv4) Properties window, select “Advanced” to
enter into the Advanced TCP/IP Setting and add IP and subnet mask in the IP browser as picture shown below.
Click the “Confirm” to finish the adding of IP segment. User can add the corresponding network segment
according to the revised IP address of the camera.
Note: The IP address to be added cannot be same with that of other computers or devices. The existence
of this IP address needs to be verified before adding.
To verify whether the network segment has been successfully added, click the “Start” and select “Operation” to
input cmd, then click OK and open DOS command window, type ping 192.168.5.26, press Enter key to display
information shown below, which means network segment adding is succeeded.
