The metal tip of the side gauge can be retracted by
turning the screw and tip if you worry about damage
to the side of your rim. However, some contact must
be maintained so you can hear if the wheel needs
adjusting.
Normal Position
(metal tip is projected)
Carbon Position
(metal tip is retracted)
(Fig. F)
- 3 -
How To Fold Down
True-Pro is completely foldable for easier
transportation and compact storage.
To fold down, follow the steps;
1. Shut the Side Gauge as narrow as possible.
2. Loosen the Lock Knob.
3. Open the Pillars slightly.
4. Fold the gauges downward and push toward the
Pillars.
5. Flip up the Leg until it touches the Gauge Stay.
6. Tighten the Lock Knob.
7. Close the Pillars until it touches the gauges.
!
Be careful not to pinch your fingers
between the body, stay and leg.
How To Use T-Gauge2
(Fig. G)
T-Gauge2
(Fig. H)
The T-Gauge2 checks the position of your True-Pro
to make sure it is centered exactly so your wheel
should be able to be trued as symmetrically as
possible.
It's crucial to check the gauge position at the
point where you work on the actual wheel.
Also you should check regularly before using True-
Pro to avoid mistakes.
(Fig. I)
T-Gauge2 Setup
Position
T-Gauge2 should be installed on the Axle Holder as
deep as the case of wheel.
Loosen the knob nut, insert into the Axle Holders.
Make sure each metal washer is located inside of the
Axle Holder to keep the angle as vertical as possible.
While pushing down the T-Gauge2, tighten the knob
nut to fix the position.
Put the Side Gauges close to the T-Gauge2, then shut
the Side Gauges by turining the adjust knob.
