Wheel Truing Stand
TRUE-PRO
instructions manual
Thank you for choosing the MINOURA
TRUE-
PRO
.
This portable wheel truing stand features our
convenient AUTO CENTERING system. ACS
allows you to perform almost every procedure
needed in building a wheel without the need for an
additional dishing tool.
Also, newly designed gauges that check vertical and
horizontal movement of the wheel are intuitive and
easy to use.
TRUE-PRO folds down completely for easy trans-
port and storage.
Please read this instructions manual carefully before
use and keep handy at all times for future references.
Important Notes
!
• Do NOT use True-Pro for any purpose other
than instructed such as display stand or
indoor trainer.
• This Auto-Centering system is not 100%
perfect so we recommend you to use a
wheel dishing tool together for much more
precise adjustment.
• Setting wheel in the correct position is
crucial. Push down the wheel to set it in
the deepest position on the Axle Holder
when you tighten the quick release skewer.
- 1 -
Arm
Vertical Gauge
Adjust Knob
Vertical Gauge
Side Gauge
Side Gauge
Adjust Knob
Arm Lock
Components
• PILLARS
Both right and left side Pillars are connected in the
Body so they will move together at the same time.
You should hold both Pillars with both hands when
opening or closing them.
• AXLE HOLDER
Axle Holder can adjust its angle to keep parallel at
any width to fit hubs properly. (see Fig. A)
It is crucial to set the wheel into the deepest position
of the Axle Holder by pushing down the wheel when
setting up the wheel on True-Pro to get better result.
If one side has been lifted up due to bad installation,
the wheel won't be symmetrical.
Axle Holder
Pillar
Leg
Body
Lock Knob
Gauge
Stay
(Fig. A)
