!
O
X
(fig. J)
4
Place the Connecting Plates at the top of the Lower Pil-
lar. Connect the Upper Pillar to the Lower Pillar then
tighten the M6x14 bolts firmly. Now the base frame is
completed.
Upper Pillar
Connecting
Plate
Lower Pillar
5
(Fig. D)
(Fig. E)
6
(Fig. H)
FOR MORE INFORMATION
For parts or service outside of Japan or North America, please con-
sult your local shop or refer our international distributor list (found
on our web site) for the distributor in your country.
MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone: +81-(0)584-27-3131 / Fax: +81-(0)584-27-7505
Email: [email protected] / Web: http://www.minoura.jp
MINOURA NORTH AMERICA
(for North American residents only)
1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Fax: 1-510-538-5899 / Email: [email protected]
MADE IN JAPAN
Copyright 2002 Minoura Co.,Ltd. All rights reserved
Assemble the cradles.
Place the Angle Adjust Plate onto the Lower Support,
then put the Alloy Stay on it. Fix three parts with the
supplied M6x20 bolt in the upper hole. (see Fig. E)
Screw the supplied M6x15 bolt in the lower hole, but
you don’t need to tighten it so firmly at this time.
Next, you'll install the bike cradles to both the upper and
lower pillars.
Disassemble the band clip first. (see Fig. H)
Wrap the stainless band around the pillar, in-sert the end
of the band between another end and the rectangle nut.
Put the plastic bracket onto the band, attach the hook or
support arm, then tighten the bolt.
Stainless Band
Plastic Bracket
The distance between the plastic frame hooks can be
adjusted to fit different sized bikes.
To do so, loosen the rear nut and adjust the position of
the hook. After adjusted to the required position firmly
re-tighten the nut.
(see Fig. F)
7
(Fig. F)
The stainless band must ONLY be used on the
upper side of the cradle. Do NOT use it on the
bottom position of the cradle. (see Fig. G)
(Fig. G)
stainless band
just putting onto the pole
8
The cradle is adjustable in degrees. If you want to move
the cradle, loosend the lower
bolt on the angle adjust plate,
change the
angle until the
displayed bike
will be
horizontally
as much as
possible then
tighten the bolt again. (see Fig. I)
(Fig. I)
To put a bike on PAIR STAND, lift the bike and gently place
the top tube into the frame hooks.
If the bike does not have a standard frame design, it should
be supported by the top tube and rear seatstay configuration.
(see Fig. J)
9
WHY MY NUT IS MISALIGNED?
The inside nut of the stainless band clamp is not square, it is rectanle.
You have to remove the stainless band to wind up it around the pole
for assembling. At this time, do NOT remove the nut from the band.
If you had removed the nut, make sure the nut direction that the
longer side must be vertical. If you see there is some space between
the nut and stainless band, the direction is wrong.