!
!
2
3
Lower Support
Angle Adjust Plate
(projection is foreside)
Alloy Stay
Frame Hook
Bicycle display stand “PAIR STAND” instruction manual
Please read this instuctions carefully before use.
Thank you for purchasing Minoura
PAIR STAND
bike display stand.
This stand can hold up to two bikes horizontally in a space as same as for only one bike.
This stand is designed for standard two wheel bicycles.
Do not use this stand for electric bikes or tandems. The weight
limit for two bikes is 30 kgs. or 66 lbs.
Make sure the stand is used on a level floor.
Failing to set-up and use this stand on a level floor may cause the
stand to fall over and cause damage or injury.
This stand requires some
assembly. You will need a M4
Hex wrench and a 13 mm
spanner in order to assemble
the PAIR STAND completely.
IMPORTANT NOTES
HOW TO ASSEMBLE YOUR PAIR STAND
1
Screw the foot adjuster to the nut located on each leg
end.
Insert four M8x55 bolts into the holes on the bottom of
the Lower Pillar, then put through the legs. The long leg
is for rear section, and the short legs are for front sec-
tion. Be sure to fit the legs to the shape of the horrow of
the bottom plate.
Lower Pillar
Rear Leg
Bottom Plate
Front Leg
(Fig. A)
(Fig. B)
(Fig.C)
Install the Reinforcement Arms between the Lower Pillar and
the Front Legs by tightening the M6x14 bolts for the pillar
side, and M6x30 bolts for the leg side. After installing the
Reinforcement Arms, tighten the M8x55 bolts firmly. Wrong
step may make you unable to install the Reinforcement Arms.
Reinforcement Arm
Reinforcement Arm
Rear Leg
Front Leg
Upper Pillar
Lower Pillar