Multi Purpose Base Stand
P-700X
instructions manual
• P-700X is designed for allowing you to setup anywhere by its super-wide
X-shaped legs. But do not mount heavy items in just one side to prevent
falling down accident.
• Adjust the length of each Foot Adjuster individually in order to keep the Pillar
stable and vertical. And tighten the Lock Nut toward the leg after adjusting.
Required Tools
1 x M5 Hex Wrencg
1 x 10mmSpanner
1 x 13mmSpanner
Made in Japan
Important Notes
(2009/07)
MINOURA JAPAN
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Phone: +81-584-27-3131 / Fax: +81-584-27-7505 / Email: [email protected]
1
2
3
5
Attach Pillar Base to the center hole on the legs with
M6x40 bolt and spring washer. (see Fig. B & C)
Pillar
Support Arm
Adjuster
Cross the legs and open every Support Arm outward.
(see Fig. A)
Correctly assembled legs
Install Pillar to Pillar Base. (see Fig. D)
Be sure the bracket of Pillar Base will be inserted into
Pillar, not placing side by side.
Tighten two M6x18 bolts temporally to hold Pillar. These
bolts will be tightened firmly in the last step.
Assemble a pair of Support Arms to Pillar with an M6x70
bolt, Flat washers, Plastic washers and a Nylon nut (see
Fig. E). And finally tighten M6x18 bolts firmly.
The direction of Pillar Base
must be as shown in Fig.B.
!
(Fig. A)
(Fig. D)
(Fig. E)
4
Raise up all Support Arms.
(Fig. B)
(Fig. C)
Leg (short)
Leg (long)
M6x40 Bolt
Spring Washer
Pillar Base
M6x18 Bolt
M6x70 Bolt
Nylon Nut
Flat Washer
Plastic Washer
Leg (short)
Leg (short)
Leg (long)
Leg (short)
All manuals and user guides at all-guides.com