Type-A: plain type bolt
Type-B: with Spring Washer
1
2
3
4
Fig. A
Fig. B
Fig.C
Fig. D
P-600AL "Closet Cyclist 2" instructions manual
Upper Hook
Main Pillar
Lower Hook
Reinforcement Bar
Rear Leg
Right Side Front Leg
Height Adjuster
Leg Base Plate
Stainless Band Clip
Thank you for purchasing Minoura "
P-600AL Closet Cyclist 2
" bicycle
display stand. This stand can hold up to two bikes in a narrow space
vertically in order to save your storage space as much as possible.
Please read this instructions manual to assemble and use the stand correctly
and safely.
Required Tools for Assembling
Bolt Type Variation
Install both side Front Legs to the
Leg Base Plate with supplied M6x35
type-A bolt, Flat washer, Collar and
M6 Nylon nut. (see Fig. A)
The Legs are different for right
side and left side.
Each Reinforcement Bar must be
inward.
M6 Nylon Nut
Collar
Flat Washer
Left Side
Front Leg
Place the Rear Leg on the Leg
Base Plate, and apply the Pillar
Base Plate onto the assembled legs.
Put the M6x40 type-A bolt with
Spring and Flat washer into the
front side hole and tighten them
temporarily. (see Fig. B)
Pillar Base
Plate
M6x40 Bolt
Rear Leg
Put the M6x40 type-A
bolt with Spring and Flat
washer into the backside
hole and tighten firmly.
After that, tighten the front
side bolt firmly too.
(see Fig. C)
M6x40 Bolt
Insert the Main Pillar onto the
Pillar Base Plate.
Apply the Backside Leg on the
back of the Main Pillar, then
tighten with the supplied two
M6x18 type-B bolts temporarily
(not firmly). (see Fig. D)
Backside Leg
M6x18 Bolt
Main Pillar
1 x 5mm Hex Wrench
1 x 13mm Open Wrench
M6x35 Bolt
Leg Base Plate
MADE IN JAPAN
