- 2 -
Upper Pillar
Hook
Arm
Leg
Foot Adjuster
Cradle
｛
1
2
3
(Fig. B)
(Fig. C)
First of all, confirm the Base Plates. They are not the same.
The upper side plate (will be attached to the Lower Pillar) has
larger holes to allow the bolts putting through, and there are 4
holes in the center area for connecting to the Lower Pillar.
The lower side plate has smaller threaded holes, and there is no
hole in the center area.
Please be sure that the hole pattern is not symmetric. The in-
line 4 holes comes to backside. (see Fig. A)
(Fig. A)
Place the Lower Pillar on the floor with the top cut
out facing up. Set the Upper Base Plate to the pillar as
shown in the Fig.C.
Screw 4 – M6x30 bolts to the threaded C-shaped
ribs in the Lower Pillar through the center
holes. Tighten the bolts with the 5mm hex
wrench.
(Tightening Torque = 4 N.m)
Lower Pillar
!
Hook material
may leave stain
on the bike frame.
For more info,
refer to page 7.
Clamp
!
Base Plate
(Upper & Lower)
Upper Base Plate
Lower Base Plate
Confirm the Lower Pillar direction.
Look at the pillar end, you will see 4 C-shaped ribs inside. (see
Fig. B)
If the C-shaped ribs are threaded, those must be at the bottom
with the non-threaded end at the top.
(Upper Pillar has a plastic cap on its top)
The cut out under
the Pillar Joint Clamp
must face forward.
Upper Base Plate
Lower
Pillar
M6x30 Bolt
!
Tighten the bolts
alternately and
equally.
Do not tighten only
one bolt with too
much force.
Safety Pin
4 in-line holes come bottom
Part Name
Pillar Joint Clamp
Required Tools
1 x M5 Hex Wrench
(included)
1 x 13mm Spanner
(not included)
How To Read Bolt Size
Length
Diameter
Ex) 6 x 30
Diameter Length
(Unit: mm)
Assemble P-500 in K-style Leg
Setting up your P-500 in the K-Style leg configuration saves valuable room
because the stand can be placed next to a wall. ONLY place the bikes on
the front side of the stand so as to maintain balance and keep the stand
from toppling over. Maximum bikes per stand is TWO (2).
Front
Back
Look at the Lower
Pillar end.
The threaded side
must come to the
bottom.
The other side is
not threaded.
4 N.m
