(ver.6.1 2017/2)
!
P-500AL-6S "PairStand"
instructions manual
(Image: P-500AL-6S in K-style leg)
FEATURES
● Save vast amounts of space by storing
two bicycles in a single space.
● Alloy pillar is lightweight, rust proof and
durable. Max load is 100 kgs (in X-style
leg mode).
● Legs are switchable between K-style
and X-style depending on the number of
bikes or setup location.
● Alloy clamp securely holds the bike
cradle and allows for easy position
changes.
● The bike hook is designed to be low
profile to get the bike on and off easily.
Soft plastic pads prevent frame from
being scratched. It fits up to 70mm
diameter frame.
● Bike Cradle is same design as Bike-
Tower20. Cradle angle and hook span
are fully adjustable.
CAUTIONS
●
For normal 2-wheel bicycle only. Tandem,
recumbent and long tail bikes may not be
used on this stand. Place heaviest bike in the
lower cradle to maintain stands balance.
●
Set stand on an even, horizontal floor. Adjust
each foot precisely to insure each of the
foot's four points touch the floor evenly.
●
Leaving a bike in the top cradle only may
cause an imbalance and the stand could fall
down. Be careful to keep weights balanced
at all times.
Contact
MINOURA JAPAN
MINOURA NORTH AMERICAN TECH CENTER
(for ALL customers, including Canada)
(for U.S. residents ONLY)
1197-1 Godo, Anpachi, Gifu 503-2305 Japan
Mon - Fri, 9 am - 5 pm (PCT)
Fax +81-584-27-7505
Phone 1-510-538-8599 / Fax 1-510-538-5899
[email protected] / www.minoura.jp
If you have question or problem on this product, please contact the shop where you originally purchase this product
or the distributor in your country first. The distributor information can be found on our web site. Only when you
cannot obtain enough service from them, you can contact Minoura directly.
Made in Japan
●
Do NOT hook the bike with the down-tube and seat-tube. Hook the top-tube.
●
Set up close to a wall to prevent the stand from falling down when setting the stand up in the K-leg configuration.
●
Do NOT try to remove the clamp from the bike cradle when installing on the pillar.
●
The clamp is made of light alloy material. Do NOT over-tighten or the bolt may come out of the housing, ruining the
clamping mechanism.
●
Tighten the bolts equally. Do NOT tighten just one bolt firmly. Failure to do so may lead to improperly tightened screws.
