If you cannot shift to either the lowest (L) or the highest (H)
position, it is possible that the inner wire of the remote shifter
cable is too long and the wire tension is loose. If so, please
adjust the tension with the following steps;
1.
1.
1.
1.
1.
Set the remote shifter lever at “H” position. Remove the re-
mote shifter device from the handlebar and straighten the cable.
2.
2.
2.
2.
2.
Remove the plastic cap located on the bottom of the cable.
(see Fig. E)
3.
3.
3.
3.
3.
Hold the adjusting screw with your right hand and push it to-
wards the direction of the outer cable, then adjust the nut with
your left hand to make the wire tension properly.
Trouble Shooting Your Remote Shifter Unit
Wire Tension
Adjusting Screw
Nut
Plastic Cap
Cable
(Fig. D)
MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE
1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN
Phone +81- (0)584-27-3131 / Fax +81- (0)584-27-7505
E-mail: [email protected]
http:// www.minoura.jp
MINOURA NORTH AMERICAN CENTER
MINOURA NORTH AMERICAN CENTER
MINOURA NORTH AMERICAN CENTER
MINOURA NORTH AMERICAN CENTER
MINOURA NORTH AMERICAN CENTER
FOR RESEARCH, DEVELOPMENT & MARKETING
FOR RESEARCH, DEVELOPMENT & MARKETING
FOR RESEARCH, DEVELOPMENT & MARKETING
FOR RESEARCH, DEVELOPMENT & MARKETING
FOR RESEARCH, DEVELOPMENT & MARKETING
1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Phone 510-538-8599 / Fax 510-538-5899
E-mail : [email protected]
Made & Quality Controlled in Japan
Copyright © 2002 Minoura Japan, All Rights Reserved.
FOR MORE INFORMATION
All manuals and user guides at all-guides.com
