- 4 -
1
2
3
!
(Fig. G)
(Fig. H)
(Fig. I)
1
2
(Fig. J)
!
If you cannot shift to either the lowest “L” or the highest “H” position, it is possible that the inner wire of the remote shifter cable is too
long and the wire tension is loose. If so, please adjust the tension with the following steps;
Trouble Shooting Your Remote Shifter Unit
Wire Tension
Adjusting Screw
Nut
Plastic Cap
Cable
(Fig. K)
Minoura Japan Head Office
Minoura Japan Head Office
Minoura Japan Head Office
Minoura Japan Head Office
Minoura Japan Head Office
1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN
E-mail: [email protected] / Fax +81-584-27-7505
http:// www.minoura.jp
Minoura North American Tech & Warranty Center
Minoura North American Tech & Warranty Center
Minoura North American Tech & Warranty Center
Minoura North American Tech & Warranty Center
Minoura North American Tech & Warranty Center
(for North American residents only)
(for North American residents only)
(for North American residents only)
(for North American residents only)
(for North American residents only)
1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Email : [email protected] / Fax 1-510-538-5899
For More Information
Set the remote shifter lever at “H” position. Remove the remote shifter device
from the handlebar and straighten the cable.
Remove the plastic cap located on the bottom of the cable. (see Fig. K)
You must not be riding the trainer when you are adjusting the
You must not be riding the trainer when you are adjusting the
You must not be riding the trainer when you are adjusting the
You must not be riding the trainer when you are adjusting the
You must not be riding the trainer when you are adjusting the
white lever on the Mag unit for load force. Make sure all parts
white lever on the Mag unit for load force. Make sure all parts
white lever on the Mag unit for load force. Make sure all parts
white lever on the Mag unit for load force. Make sure all parts
white lever on the Mag unit for load force. Make sure all parts
have stopped spinning. Do not try to adjust the lever with your
have stopped spinning. Do not try to adjust the lever with your
have stopped spinning. Do not try to adjust the lever with your
have stopped spinning. Do not try to adjust the lever with your
have stopped spinning. Do not try to adjust the lever with your
feet while riding.
feet while riding.
feet while riding.
feet while riding.
feet while riding.
Hold the adjusting screw with your right hand and push it towards the direction of
the outer cable, then adjust the nut with your left hand to make the wire tension
properly.
MADE IN JAPAN
Place the holder onto the handlebar, shut the holder, and pull up the bolt then tighten it. (see Fig. I)
Fully loosen the knob bolt on the plastic holder until it stops then push down the bolt to open the holder. (see Fig. H)
You can install the remote lever on anywhere the diameter is between 22.2mm (7/8”) and 31.8mm (1-1/4”) like as on the handlebar.
HOW TO INSTALL THE REMOTE LEVER
Shim
Depends on the diameter of your handlebar, you must adjust the shim as follows;
• 22.2mm (7/8”) - 25.4mm (1”):Install both shims.
• 28.6mm (1-1/8”):
Install either right or left side shim.
• 31.8mm (1-1/4”):
Remove both shims.
When you install the shim on the plastic holder, make sure the direction of the shim as shown in Fig. J.
