!
If the rear tire has touched any other parts than the Drive Roller, the part may be
damaged and your tire will wear out quickly.
!
It is impossible to adjust the rear wheel position by adjusting the left side coupling
position. It just works to adjust the coupling distance.
7.
To remove the bike from LR240, loosen the knob first, then lift up the clamp lever.
If you remove the bike without changing the roller position, the next installation may become
difficult because the rear wheel has been pushed forward by the roller.
- 7 -
Decrease
Increase
How To Operate Remote Shifter
LR240 comes with a convenient remote shifter device.
By installing it on your handlebar or stem, you can adjust the
resistance level in 7 levels without getting off the bike.
The remote shifter should be used in conjunction with the gears
on your bike to achieve maximum efficiency in your workout.
How to install the remote shifter
1) Wind the flexible plastic band around the handlebar,
2) Put the hook to the gutter on the plastic shifter base,
3) Flip up the lever to lock.
How to increase the resistance level
Twist the shifter lever toward "H" symbol.
How to reduce the resistance level
Twist the shifter lever toward "L" symbol.
"L" is not zero resistance. There is still some resistance
at "L" level due to the roller compression to the tire.
The remote shifter is pre-adjusted to fit the standard handlebar
size; 22mm (7/8") diameter.
If it becomes loose or too tight, or you need to install the shifter
onto an oversized handlebar or stem, adjust the band length by
turning the plastic screw on the band with an M4 hex wrench.
(Please be advised that the hex wrench doesn't come in the package)
Hook
Lever
1
2
Required Tool:
1 x M4 Hex Wrench
The plastic band and screw are not so tough. Do not
tighten too much. You should take off the hook before
adjusting.
!
!
(Fig. O)
(Fig. P)
(Fig. Q)
(Fig. R)
