1
2
1
2
3
Decrease
Increase
How To Operate Remote Shifter
V270 comes with a convenient remote shifter device. By installing it on your handlebar or stem,
you can adjust the resistance level without getting off the bike.
The remote shifter should be used in conjunction with the gears on your bike to achieve maximum
efficiency in your workout.
How to install the remote shifter
1) Wind the soft fabric band around the handlebar
2) Hook the metal ring to the gutter on the plastic shifter base
3) Flip up the lever to lock
How to increase the resistance level
Twist the shifter lever toward "H" symbol
How to reduce the resistance level
Twist the shifter lever toward "L" symbol
!
"L" is not 0 resistance. There is still some resistance at "L".
The remote shifter is pre-adjusted to fit the standard handlebar size;
22mm (7/8") diameter.
If it becomes loose or too tight, or you need to install the shifter onto
an oversized handlebar or stem, adjust the fabric band length.
At this moment, you should pull down the guide pin for easier job to
loosen the band.
How To Adjust Remote Cable
If you cannot shift at L or H position, it's time to adjust the remote cable.
1) Set the remote shifter lever at "H" position.
2) Pull off the black plastic cap on foot of the cable, then the adjusting screw appears.
3) While pushing the outer cable toward the shifter, push the adjusting screw to the cable.
4) Turn the lock nut until it touches the Mag unit.
5) Insert the plastic cap again.
- 7 -
Adjusting Screw
Lock Nut
Cap
Tighten Nut
Guide Pin
