MINOURA eRDA-850LW series, Instruction Manual, Page: 8 / 8

- 8 -
MINOURA JAPAN HEAD OFFICE MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE MINOURA JAPAN HEAD OFFICE MINOURA JAPAN HEAD OFFICE
1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN
Fax +81-584-27-7505 / E-mail: minoura@minoura.jp
http://www.minoura.jp
MINOURA NORTH AMERICAN WARRANTY CENTER ( MINOURA NORTH AMERICAN WARRANTY CENTER ( MINOURA NORTH AMERICAN WARRANTY CENTER ( MINOURA NORTH AMERICAN WARRANTY CENTER ( MINOURA NORTH AMERICAN WARRANTY CENTER ( For U.S. Residents only) For U.S. Residents only) For U.S. Residents only) For U.S. Residents only) For U.S. Residents only)
In Canada, have your local shop contact Norco Products for warranty and parts service. In Canada, have your local shop contact Norco Products for warranty and parts service. In Canada, have your local shop contact Norco Products for warranty and parts service. In Canada, have your local shop contact Norco Products for warranty and parts service. In Canada, have your local shop contact Norco Products for warranty and parts service.
1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Fax 1-510-538-5899 / E-mail : MinHelp@ATTglobal.net
FOR MORE INFORMATION
Proudly made to exacting standards in Japan.
Copyright © 2003-2004 Minoura Co., Ltd., All Rights Reserved.
CHANGING YOUR NON-REMOTE TRAINER TO A REMOTE TRAINER
(Fig. P)
You can change your dial type Mag unit to be a remote controlable one.
Of course, the opposite way is possible.
1
Remove the dial lever by removing two small
screws.
2
3
4
Remove the bottom spring holder by removing two medium screws
and remove the inside spring. You should keep a memo where the
bottom pin of the spring was installed for returning to dial type
again.
Change the spring position as shown in the Fig. P.
Place the spring holder onto the spring. Be sure the top pin is inserted into the slot of the holder.
Twist the spring holder in the direction of clockwis and push down it to fit to the hole on the lower case
then tighten the screws.
Spring Position for
Remote type
5
6
Install the remote cable bracket at the postion where the dial lever sit by the removed small screws in
Step-1.