Tire Holder for Fat-Bike
DS-150F
instructions manual
(ver.1.1 2016/9)
• Fits up to 5-inch width fat tire.
• Install the Tire Rack together with the Wheel Support of on the Step-Bar.
Be sure the Tire Rack is not fixed and freely movable even though the
Wheel Supports are fixed onto the Step-Bar.
• Adjust the Wheel Support frame span prior to installing the Tire Rack.
• The shorter Step-Bar found in the original DS-150 doesn't come with the
DS-150F. Only the longer one is in the kit.
<Overview>
Be sure the Tire Rack is
positioned out of the Wheel
Supports.
Make sure the shorter
guide side is positioned
inward of DS-150F.
Tire Rack
Wheel Support
Step-Bar
!
DS-150F
※
※
Warranty Period : 1-year
For more information, visit:
http://www.minoura.jp/
english/support/cs/contact.html
Schematics
Step-Bar
Cap Bolt M6x12
M6 Spring Washer
M6 Flat Washer
Cap Bolt M6x10
Plate Nut
Tire Holder (Red)
Wheel Support
Insert the Plate Nut into
the hole on the Wheel
Support first, then put
the Step-Bar through
and tighten the bolt
from outside to hold.
Adjust The Frame Span
Span
Tire Holder (Red)
Adjust the Wheel Support frame span to fit the actual tire
width.
Loosen the M6x12 Cap Bolts, and change both side
Wheel Support frame position as equally as possible while
maintaining the red Tire Holder horizontal.
After adjustment, tighten the cap bolts firmly.
