12 | minnkotamotors.com
©2018 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE GAS SPRING PIN
j. Put a 1/4-20 x 2 1/2" Screw (Item #4) in each of the
drilled locations. The Screw should pass through the
Mount Plate and the boat deck.
k. Place a Flat Washer (Item #5) and then a Nylock Nut
(Item #6) at the end of each screw as shown and
secure. Make sure all hardware is secure.
ITEM(S) NEEDED
#5 x 6
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
Screw
Deck
Flat Washer
and Nylock Nut
a. Position the motor to the stowed position with the
Pull Grip and Cable to disengage the latch bar,
allowing the motor to fold into a flat position.
b. Once in the stowed or flat position, the Gas Spring
Pin and Spacers can be installed.
5
Installing the Gas Spring Pin
1
#6 x 6
#4 x 6
