MKA-42 OR MKA-52/62
QUICK RELEASE BRACKET
1862014 & 1862016
Item /
Assembly
Part #
Description
Qty.
A
Includes 2-6
2994829
BAG ASSY-MAX QUICK RELEASE
1
2
2073408
SCREW-1/4-20 X 7/8 PPH S/S
6
4
2261713
WASHER-1/4 FLAT 18-8 SS
6
6
2263103
NUT-1/4-20 NYLOCK SS
12
8
2500000
SCREW-1/4-20 X 2 1/4 PPH S/S
12
B
Includes 10-16
✖
QUICK RELEASE MNT STD ASSY *MKA-42* *SHORT*
1
C
Includes 10-16
✖
QUICK RELEASE MNT LG ASSY *MKA-52/62* *LONG*
1
10
✖
SLIDE PLATE
1
12
✖
BASE PLATE
1
14
2370101
THUMB SCREW
1
16
2371718
LOCKWASHER-1/4” ZINC
1
p
2374911
INSTR SHEET-MAX QUICK RLS.
1
The MKA-42 and MKA-52/62 are recommended for use with all Minn Kota
®
Fortrex
®
, Maxxum
®
, Edge, and Ultrex freshwater trolling motors.
p
Not shown on Parts Diagram.
✖
This part is included in an assembly and cannot be ordered individually.
TOOLS AND RESOURCES REQUIRED
• Drill
• 9/32” Drill Bit
• #3 Phillips Screw Driver
• Awl, pencil or similar marking tool
• A second person to help with
the installation
MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to
the centerline of the boat as possible. The motor must not
encounter any obstructions as it is lowered into the water or
raised into the boat when stowed and deployed. Make sure the
motor rest is positioned far enough beyond the edge of the
boat. Make sure the area under the mounting location is flat,
clear to drill holes and install nuts and washers.
12
12
10
10
2
2
A
A
B
B
C
C
4
4
6
6
8
8
WARNING
For motors with Lift Assist (Fortrex and Ultrex), the lift
cylinder should be disengaged until installation is complete
to prevent injury.
NOTICE:
For Ultrex motors, please review the “Disconnect
the Gas Spring” section of the Ultrex Owner’s Manual
(#2297160) online at
.
NOTICE:
For Fortrex motors, please review the
“Disconnect the Gas Spring Pin” section of the Fortrex
Owner’s Manual (#2287100) online at
.
Complete Typical Installation
14
14
16
16
1 | minnkotamotors.com
©2020 Johnson Outdoors Marine Electronics, Inc.
