MINLEON
’
s
MULTIFUNCTION MINI-CONTROLLER v3
QUICK REFERENCE GUIDE
PRECAUTIONS & INSTALLATION REQUIREMENTS
1.
If using outside then ensure that the controller is mounted from the mounting eye piece with the
power & USB sockets facing downwards. Put caps in place on the USB port if not used.
2.
If the controller is beyond 20 feet from the first light, Minleon’s Sender-Receiver accessory is
needed. This will allow up to 300 feet between the controller and first light.
3.
Never disconnect and connect lights when the controller is powered, as this may cause permanent
damage to the lights and/or controller.
4.
Do not place lights or controller in areas where there is extreme heat or cold.
5.
Do not strain the cables of the lights as damage may occur to the wiring.
6.
Always keep the plug cap on at the end of the light string when not used.
7.
Firmly tighten all plugs, do not over-tighten.
8.
Do not drop controller, remote or lighting on hard surfaces.
9.
Do not use if there is any damage to the controller, wiring or lighting.
10.
Do not use detergents on the controller, remote or lights as this may cause permanent damage. Use a
soft clean rag to clean the controller, remote and lights
.
INTRODUCTION
The Minleon Multifunction Mini-Controller is an entry level controller capable of controlling up to 500 lights
on a single string, but can operate many thousands of lights wired in parallel using Minleon accessories.
Comes with multiple effects built in that can run at different speeds and colors.
The USB port allows live control via PC and is controlled using Minleon's
LightShow Pro
software.
There is a wide variety of accessories available for the Mini-Controller that will extend the capabilities of
the Minleon RGB system.
PARTS AND CONNECTION
1: Multifunction Mini-Controller
The Minleon Multifunction Mini Controller has multiple functions in a small package.
2: Mini-Controller Remote
The Mini-Controller remote control expands the user’s control of the RGB lights in
multiple ways.
3: 12VDC Power Supply
12VDC, 5-amp power supply powers up to 125 Minleon RGB lights with the
controller.
4: Minleon RGB Lights
A variety of different lights, tubes and strip lighting are available from Minleon
Always power off the controller before connecting and disconnecting lights
Diagram for connecting the power supply and lights
5-amp power supply
Maximum of 125 Minleon RGB
Lights with 5-amp power supply
Adding additional lights
The Minleon Multifunction Mini-Controller can control up to 500 Minleon lights (additional power considerations
are required). Connect additional light strings using Minleon accessories (Copy T’s, Power T’s), power supplies and
lights.
Setting the number of lights connected to the Controller
Turn the lights on, then hold the button for more than 1 second. All active lights
will turn on
red
with the last active light flashing
blue
.
Press
Fx↓
to decrease the number of lights connected.
Press
Fx↑
to increase the number of lights connected.
Press to return to normal operation.
