※
If the symptom is not improved after corrective action, the handpiece might be defective. Please ask for repair.
※Any other troubles or obscure points, please contact our minitor dealer.
Condition
Investigation
Corrective action
Motor does not run.
Please plug an AC cord.
Is an AC cord unplug?
Motor is overheated while running.
Please replace e equivalent fuse.
Is a fuse blown?
Use the handpiece within the green lights of
the load meter on the powerpack.
Do you use the handpiece with excessive loads?
Unusual noise and/or vibration occurs.
Ask us for repair.
Make sure if the noise and/or vibration occurs
when the handpiece runs in slow rotation speed.
Replace carbon brushes.
Are the carbon brushes worn away?
While a foot switch is connected with the powerpack,
the start/stop operation is done only by the foot switch.
Is a foot switch connected with the powerpack?
Hand switch does not work.
１０.
Precautions
7
8
１）Please be careful about heat that sometimes Recipron generates in continuous use.
２）Do not poke the installed tools in the front wall in operation. Recipron has structure that aborbs the
impact, but it may damage the internal structure.
３）Do not provide grease other than the specified spot.
４）For safety, always put the body cover on the main body and tighten with the screw.
５）Please be careful when you use for grinding or polishing in wet process because it may cause some
problems.
１２.
Trouble Shooting
１３.
Maintenance and inspection
●RECIPRON requires lubrication with a few drops of light spindle oil through the lubrication gate, at intervals of 8
hours total operating time.
When you do not use for a long time, provide spindle oil about 0.3cc (1 or 2 drops) in every 1 or 2 month.
●Please check if there is some damage or not on the case and cord.
●Please check if there is accumulated dust, oil, water and so on or not.
※Please maintain and inspect a power pack.
■
Neglecting maintenance and inspection ,could result in accident and/or failure.
Warning
Ｒｕｂｂｅｒ Ｃｒａｄｌｅ
ＲＭ１１
１１.
Accessories
Carbonbrush 1set （２pieces）
ＫＥ－５８０
Hexagonal Wrench
ＨＳ-２.０
