8. Install the retention hook to secure the driver
side loor mat from any movement. Follow
installation steps a, b, and c below.
a) Use a #3 Phillips screwdriver to remove the
screw from the transmission cover shown below
in Figure 6.
b) Locate the retention hook; poly spacer and
¼”x 1.75” machine screw; shown in Figure
7. Insert the screw through the hole in the
retention hook and place the black poly spacer
on the bolt below the hook.
c) Insert the hook assembly through the
transmission cover and tighten using a #3
Phillips screwdriver. Orient the loor mat hook
so it points straight toward the gearshift as
shown in Figure 8.
9. Install the driver side loor mat and engage
it into the retention hook. The driver mat must
be pushed all the way forward so the front lip
is makes full contact with the lower dashboard
kick panels. Nest the left rear edge of the
passenger mat over the top of the right rear
edge of the driver mat.
10. Pull the driver side loor mat to the left
to make sure that the retention hook is fully
engaged
and that the mat is securely fastened to the
loor. If the hook is not functioning properly or
the mat cannot be securely installed, do not
use a Minimizer loor mat on the driver side of
the vehicle.
11. FAILURE TO PROPERLY INSTALL THE
RETENTION HOOK FOR THE DRIVER SIDE FLOOR
MAT MAY ALLOW THE MAT TO SHIFT, WHICH MAY
INTERFERE WITH PROPER FUNCTIONING OF THE
VEHICLE’S PEDALS, POTENTIALLY RESULTING IN
LOSS OF CONTROL OFTHE VEHICLE AND SERIOUS
INJURY OR DEATH.
12. Move the accelerator, brake, and clutch
pedals through their full range of motion to
conirm there is no interference with the
Minimizer loor mat.
13. Prior to operating the vehicle, read the
Safety Instructions for Vehicle Operation.
PETERBILT FLOOR MAT KIT SPECIFICATIONS:
• Kit FKPB4B shown in Figure 1 is compatible
with Peterbilt 378, 379, 385, 357 trucks model
years 2006-2007.
•
Trucks equipped with a factory thermos
holder require hand trimming of the center mat.
A raised trim line is molded into the loor mat to
use as a guide and for liquid containment.
•
Passenger side loor mat are not compatible
with a ixed base passenger seat with under
seat battery storage. See Figure 2 below for
photo seat with battery storage.
1. Remove other loor mats from the vehicle
before installing Minimizer loor mats.
2. Install the Minimizer loor mats right side up,
with the Minimizer logo visible.
3. Each Minimizer loor mat is contoured to it
a particular location in the vehicle and may be
used safely only in that location.
4. The Minimizer loor mat package contains
one driver mat, one passenger mat and one
center mat.
5. Verify if the truck is equipped with a
factory thermos holder between the driver
and passenger seat as shown in Figure 3.
If no thermos holder is present, install the
center mat so the logo reads from left to right
when facing forward in the cab. If the truck is
equipped with a thermos holder, use a utility
knife to trim the red shaded portion of the
center mat as shown in Figure 4.
6. For cases where a ire extinguisher is
mounted behind the driver seat, the left rear
corner of the center mat shaded in yellow may
be trimmed to allow for clearance.
7. Next install the mat for the passenger side of
the vehicle as shown in Figure 5.
Figure 4 - Trimming Diagram
Figure 5 - Passenger Mat Fit
Figure 3 - Factory Thermos
Figure 8 - Proper Hook Orientation
Figure 6 - Screw Removal
Figure 7 - Hook and Spacer Assembly
Figure 1 - KIT FKPB4B Contents
Figure 2 - Passenger Seat with Battery Storage
