miniland Warmly Twin, Manual

Page: 17 / 68

17
NOTE 1: The contents of the receptacle will take between 30 and 60 minutes to reach
the temperature set, according to the material, the volume of the contents in the
receptacle(s), and the initial temperature of the contents, etc.
7. The temperature will be held as long as may be necessary as long as the liquid in
the basin stays in contact with the receptacle inserted.
8. If it is not stopped manually, the device will terminate the temperature holding
process once all the water in the tank has been used.
5.4. FUNCTION 3: STERILISATION
In order to perform the sterilisation function, follow the following instructions:
1. Place the device on a suitably flat surface, making sure that it is out of the reach
of children.
2. Insert the AC plug (4) into an electrical socket.
3. Add 100 ml of water to the heating chamber.
4. Place the baby bottle(s) face down inside the heating basket (5) together with any
other accessories (nipples, dummies, etc.).
5. Place the hood (6) over the main body of the device.
6. Subsequently, select the sterilisation function (10) on the device and by default
eight minutes will appear on the screen as the time assigned to the process.
7. Increase or reduce the time according to your requirements. After five seconds, the
green light will change to red, meaning that the device has started the heating cycle.
NOTE 1: The steam which is released during the sterilisation process is very hot The
device must not be touched whilst it is being used.
8. The status indicator light and the device’s heater will power themselves down
automatically when the sterilisation process has concluded. It is recommended that
you allow the device to cool down for a few minutes before opening the cover. After
this, remove the baby bottles and accessories.
NOTE 2: Allow the steriliser to cool down for at least 20 minutes before sterilising again.
NOTE 3: After the necessary cooling of the heating chamber, always remove any
remaining water from the it after each use, making sure that you leave it completely dry.
NOTE 4: If you wish to terminate the heating or sterilisation process before the time
indicated runs out, keep the power button (14) pushed down for four seconds.
5.5. LOCATING FAILURES
ENGLISH
SYMPTOMS POSSIBLE CAUSES AND CORRECTIVE
MEASURES
The screen is turned off Check that the device is plugged in and push
the power button
An alarm sounds and the
process has not finished
There is not enough water in the heating
chamber. Replenish it and restart the process
The device has reduced
effectiveness when heating
Check if there are any lime deposits in the
heating chamber. Clean the chamber by
following the instructions in point 6 as many
times as may be necessary nor normal
operation to be restored
The device works but it does
not heat up
Other malfunctions
Get in touch with the Miniland technical service