OPERATING THE BUG DETECTOR WITH ANALOG AND
DIGITAL
1.
Open the plastic battery cover on the back of the device.
2.
Insert 2 AAA batteries.
3.
Put the plastic battery cover back into place.
4.
Draw out the antenna.
5.
Move the Mode Switch into Alarm Mode. The green Power
Indicator Light should be on.
6.
Adjust the Sensitivity Dial accordingly.*
During initial set up, turn the sensitivity tuner to the
plus (+) side until the yellow Level 1 indicator light
turns on — or is flickering.
7.
Hold the detector close to any area you suspect has a
transmission device.
8.
If there is a transmission device, the detection gauge will start
lighting up, and the alarm will begin to sound.
*NOTICE: If you are in an area with little to no transmission devices,
then high sensitivity is suggested.
If you are in an area with many transmission devices, proceed with
the following actions:
1. Move away from all possible transmission devices —
usually by standing in the middle of a large room or going outside.
2. Adjust the sensitivity down until all the indicators lights
are off or at least only the first indicator light is on.
3. Go back inside and start moving around the room you
suspect has a transmission device. As you get closer to the source, the
indicator lights will light up one by one.
Ultimately, you may have to adjust the sensitivity as you go to find
the best level for your environment.
Earphone
Jack
Low
Sensitivity
High
Sensitivity
Chain Clip
Hook
