AN-48-003 Rev. H (Jun 09, 2022) This document and its contents are the property of Mini-Circuits ECO-013719 Page 14 of 44
2.3
Power Sensor Physical Setup
2.3.1
For CW and RMS power sensors, align the red dot at
the Power Sensor
USB connection with the one on the supplied cable and press in until you hear a ‘click’.
2.3.2
For Peak power sensors,
simply
connect the standard USB cable supplied to the
USB port.
1.
Note the maximum rating power input in the datasheet and the conditions
specified for it. Exceeding these values may damage the power sensor.
2.
Do not exceed the operational safe power levels for extended periods of time.
2.3.3
For USB control,
connect the USB type A plug of the supplied cable to the
computer USB port and begin testing. In RC models the RJ45 connector remains unconnected
when in USB control.
Figure 2.3.1:
Plug cable into unit
Figure 2.3.3a:
Connections for USB control of a CW or RMS RC model
CAUTION