Minelab EQUINOX 700, Instruction Manual

Page: 6 / 61

11
1
10
23
18
3
14
4
28
29
8
2
22
30
5
19 17
26
15
13
21
24
20
27
25
9
6
7
16
12
22
6
CONTENTS
Parts Overview
SCREEN PROTECTOR APPLICATION
Applying a screen protector will protect your screen
against scuffing and scratching from normal use�
NOTICE: Never clean the Display lens using
solvents or alcohol-based cleaners� To clean the
Display lens, use a slightly damp cloth with mild
soap detergent�
1. Remove the thin plastic film from the detector screen�
Make sure the screen is free of dust and fingerprints�
2. Peel the backing off of the screen protector, being
careful not to touch the adhesive side�
3. Hold the edges of the screen protector, align it to the
screen, and apply gently�
4. Wipe any bubbles to the edge with a soft, clean cloth�
5. Peel off the front layer�
1. Control Pod
2. Display
3. Keypad
4. Side Buttons (×3/×4*)
5.
Speaker
6. Flashlight
7. Headphone Socket 3�5 mm/⅛"
(with waterproof dust-cap)
8.
Charging Interface
9. Coil Connector Interface
10. Handgrip
with vibration and internal
Lithium-ion Rechargeable Battery
11. Armrest
12. Stand
13. Armrest Lock
14. Armstrap
15.
Armrest Rail
16. Shafts
17. Upper Shaft
18. Upper Camlock
19. Middle Shaft
20.
Lower Camlock
21. Lower Shaft
22. Shaft Yoke
23. Coil (with cable)
24. Skidplate
25. Coil Cable
26. Coil Connector
27.
Retaining Ring
28. Teardrop Washers (×2)
29. Coil Bolt
30. Yoke Bracket
* EQUINOX 900 only