Minebea Intec Puro EF-4PDDP Series, Operating Instructions Manual

Page: 35 / 63

— ON enabled*
— g Gram
— OFF disabled
— ON enabled*
— lb Pound
— OFF disabled
— ON enabled*
— oz Ounce
— OFF disabled
— ON enabled*
— lb:oz Pound / Ounces
— OFF disabled*
— ON enabled
— RESET Factory setting
— NO not restored*
— YES enabled
— END Leave menu level
— ZERO.R Zero Range
— 2% zero up to 2% capacity
— 10% zero up to 10% capacity*
— A.TARE Automatic Tare
— OFF disabled*
— ON 1st stable weight is tared
— ON-ACC Stable loads within the accept limits are tared
(in Checkweighing mode)
— BEEP.SI Beeper Signal (in Checkweighing Mode)
— OFF disabled*
— ACCEPT Alarm when the weight is within the Accept
range
— UNDER Alarm when the weight is under the low limit
— OVER Alarm when the weight is over the high limit
— UNDOVR Alarm when the weight is outside Accept range
— BEEP.KE Button Sound
— OFF disabled
— ON enabled*
— TOT.SET Totalization Setting
— OFF disabled
— AUTO Automatic Totalization
— MAN Manual Totalization*
— LIGHT.T Back lighting time (D.LIGHT = AUTO)
— 3 SEC Backlight off after 3 minutes of no activity
— 5 SEC Backlight off after 5 minutes of no activity*
— 8 SEC Backlight off after 8 minutes of no activity
— D.LIGHT Display Backlight
— OFF disabled
— ON enabled
6.2.4 Menu Selection [OP.FUNC]
Enter this menu to setup scale parameters.
Default settings are identified by an "*"
OP.FUNC
6 Menu Settings Bench scale Puro®
Minebea Intec EN-33