Minebea Intec Maxxis 5 Phase PR 5900/81, Operating Instructions Manual

Page: 51 / 94

6 Application
6.1 Maxxis 5 connected directly/via Network to PC
Recipe management runs on the PC with program PR 8400 (P).
PR 8400 is conigured for Maxxis 5 using the "Phase" application (referred to as the
"Phase-Controller" from this point onwards). The recipe control runs on the batch server.
Maxxis 5 is connected to the PC via Ethernet.
The batch server can communicate with multiple devices via OPC server PR 1792.
When batching starts, the recipe remains in the PC. Only the data from the active
batching phase is downloaded to the device and started up.
The device runs through the batching phase independently. PR 8400 (P) and the
Phase-Controller visualize the current status.
The container valve(s) (coarse and ine valves) must be connected to the device. An
external SPS that processes these output signals further does not have to be used.
The SPM output and SPM input address must be speciied in the component parameters
for PR 8400 (P).
6.2 Examples with Local Inputs and Outputs
6.2.1 General Information
In the following examples, all inputs and outputs are activated by the Phase-Controller
directly. The SPS does not intervene in the controls. It does not use any data provided for
this weighing point by any proxy server.
The SPM addresses can be found in Chapter
8 .
6.2.2 Example 1
In program PR 8400 (P), the following components are deined for WP
‑
A:
- The "Mehl" ("lour") component with batching mode B1 uses SPM output address X24.
- The "Zucker" ("sugar") component with batching mode B1 uses SPM output
address X25.
If a recipe uses these components, the data for the current component is transferred to
the Phase-Controller and started.
6 Application Phase PR 5900/81
Minebea Intec EN-49