4.3 Connection with power supply and the ground
Connect and ground the power supply with the terminals on the rear panel shown as
below igure.
100 V AC to 240 V AC (Permissible range: 85 V AC to 264 V AC)
1
(1) D-class single grounding
CAUTION
Warning of personal injury.
Connect the power supply and the ground correctly as shown in the igures and use
within the prescribed power supply conditions (refer to Chapter
).
Note:
-
Grounding should be D-class single grounding. Otherwise, noise from other devices
may cause malfunctions.
-
Perform single grounding with a protective earth terminal to ensure the device is
compatible with CE mark applicable standards and JIS standards.
4.4 Connecting the servo control interface
This unit controls the servo motor by connecting the servo ampliier and its components
to the servo control interface connector (SERVO CONTROL) on the rear panel. After
wiring, the functions of PIN A5, A6 and B6 to B8 are activated by shorting across each
input and COM 3 with a contact point or open collector.
(Open collector rating VCE = 35 V DC, IC = 40 mA DC MAX)
Weight Controller CSD-918
4 Wiring
EN-28
Minebea Intec
Summary of Contents for CSD-918 Series
Page 239: ......
