Minebea Intec CSD-918 Series, Operating Instructions Manual

Page: 209 / 240

— BATCH FINISH ACTIONS see Chapter 11.8.2
— DISCHARGE FINISH ACTIONS see Chapter 11.8.2
— MAXTIME OF COMPENSATION see Chapter 11.8.2
— COMPENSATION FLOW EVAL see Chapter 11.8.2
— SEQUENCE CONTROL 2/3 Sequence control screen 2/3
— A.F.F. COMPENSATION see Chapter 11.8.2
— BATCH FINISH OUTPUT OFF see Chapter 11.8.2
— TARE BATCH START DELAY see Chapter 11.8.2
— BATCH MONITORING TIMER see Chapter 11.8.2
— BATCH START DELAY TIMER see Chapter 11.8.2
— F-FLOW COMP. STOP TIMER see Chapter 11.8.2
— M-FLOW COMP. STOP TIMER see Chapter 11.8.2
— D-FLOW COMP. STOP TIMER see Chapter 11.8.2
— WAITING TIME FOR JUDG. see Chapter 11.8.2
— SEQUENCE CONTROL 3/3 Sequence control screen 3/3
— DISCH. MONI. TIMER see Chapter 11.8.2
— DISCH.-GATE CLOSE DELAY see Chapter 11.8.2
— BATCH FINISH OUTPUT ON see Chapter 11.8.2
— DISCH. FINISH OUTPUT ON see Chapter 11.8.2
— MIXING FINISH OUTPUT ON see Chapter 11.8.2
— MIXING TIME OUTPUT ON see Chapter 11.8.2
— MENU 1/2 Menu screen 1/2
— CALIBRATION Calibration screen
— CALIBRATION 1/2 Calibration screen 1/2
— DIVISION see Chapter 6.3.4
— WEIGHING CAPACITY see Chapter 6.3.5
— ZERO ADJUSTMENT see Chapter 6.3.6
— ZERO POINT MV/V see Chapter 6.3.6.2
— SPAN ADJUSTMENT see Chapter 6.3.7
— SPAN POINT MV/V see Chapter 6.3.7.2
— PITCH CONFIRMATION see Chapter 6.5.3
— PITCH CONFIRMATION SET see Chapter 6.5.1
— DECIMAL POINT see Chapter 6.8.1
— CALIBRATION 2/2 Calibration screen 2/2
— FINE ADJUSTMENT see Chapter 6.4
— DIGITAL LINEARIZE see Chapter 6.6
— BRIDGE POWER SUPPLY see Chapter 6.3.3
— OL DISPLAY CONDITION see Chapter 6.8.2
— UNIT see Chapter 6.8.3
— ADJ. GRAV. ACCELERATION see Chapter 6.8.4
— CALIB. PLACE NO. see Chapter 6.8.4
— CALIB. PLACE G.A. see Chapter 6.8.4
— MENU 1/2 Menu screen 1/2
20.1.6 CALIBRATION
WEIGHING
CALIBRATION
20.1.7 SERVO CALIBRATION
WEIGHING
20 Appendix Weight Controller CSD-918
Minebea Intec EN-207