4
5
3.
Insert the castor wheel screw through
a hole in one of the chassis plates.
Thread a nut onto the screw and
tighten it.
Insert the two M4 x 30 screws through
the other two holes in the chassis
plate. Slide the guideplate over the
screws then tighten a nut onto each
screw.
4.
Attach a sticky pad to each of the
motors. Stick the motors onto
the chassis plate as shown using
the guideplate to ensure correct
positioning.
5.
Twist another nut on to the end of
each screw so that approximately 7mm
of thread is exposed on the shorter
screws and 12mm of thread is exposed
on the longer screw.
6.
Fit the second plate over the screws
and secure it using three nuts.
guideplate
