TempMinder® MRI-200HI Wireless Thermometer/Clock
Specifications:
-
Remote Temperature Range: -40°C to + 65°C (-40°F to +150°F)
-
Remote transmission Distance: Max 50 meters (164 ft)
-
Accuracy: +/- 1°C (2.0°F)
-
Power Supply: 2 “AA” bat 2 “AAA” batteries (not included)
Functions:
-
Remote temperatures (up to 3 RS10 transmitters may be used)
-
Indoor Temperature
-
°C or °F selectable
-
Min/Max memory (in & out)
-
12/24 hr clock with seconds display
-
Calendar
Congratulations on having purchased (or received) this fine MRI-200HI TempMinder®.
If you have any questions or concerns, feel free to contact us at any time (information below).
These instructions are purposely non-technical (written by a “non-engineering” type guy with input from Minder’s
non-tech
staff
members only).
Operating Directions (Powering up):
Remove the clear overlay on the receiver (if you don’t, the numbers will never change – ha!!!)
Remove the battery compartment doors from the receiver and any RS10 transmitters to be used. The remote transmitter
covers may be hard to remove. Press “in” and push “down” hard in the direction of the arrow. We apologize if this seems
too difficult. However, in order to maintain a certain level of water resistance it was this or screws!
Insert 2 “AA” alkaline batteries in the indoor receiver (FIRST). If there are no numbers on the LCD screen, you either have
dead batteries or one of them is in backwards!
Insert 2 “AAA” alkaline batteries in an RS10 remote transmitter (small white thing). Wait for the temperature to appear on
the receiver and “Channel 1” in the upper left corner. If using more than one remote transmitter (up to 3 possible), you
may wish to mark this transmitter as #1. You may now install the batteries in a second transmitter. Again, wait until a
“channel 2” appears, then mark the transmitter as #2. Repeat if you have a 3rd transmitter. The receiver automatically
assigns channel numbers (upper left corner of the screen) as it recognizes each signal.
Supplemental instructions when using more than one RS10 transmitter
Short Version (multiple transmitters):
-
Insert 2 AA batteries in Receiver.
Do not touch ANY buttons until the following is completed:
-
Insert 2 AAA batteries in first RS 10 transmitter (wait for “CH1” temp to appear)
-
ONLY After
Red Glow in first RS10 disappears, insert 2 AAA in 2
nd
transmitter (wait for “CH2” temp to appear).
-
After
Red Glow in second RS10 disappears, insert 2 AAA in 3
rd
RS10 transmitter.
Please understand that even though the receiver and the remote are close together (side by each?), the temperatures will
not match exactly. It can take up to 48 hours for them to come within 1°C (2°F).
KNOW YOUR CONTROLS!!!
°C /°F Button
-
We really hope this button does not need an explanation!!!
MODE BUTTON
-
This button is needed to convert the unit to MANUAL SETTING MODE so that you can program the correct time and date.
To activate, press and hold for 3 seconds. When in the normal standby mode, press this button to see the correct week
day, time, or date.
-/MIN/MAX (Minus) Button
-
In the MANUAL SETTING MODE, this button lowers any numbers (hour, minute, month, etc).
-
In the normal STANDBY MODE, press and release to see the Minimum in/out temperatures since last cleared.
-
Press it again for the Maximum in/out temperatures since last cleared.
