Mimo Monitors MY-1090CV, User Manual, Page: 18 / 30

Ver 0.1 (6/21) PAGE 18 OF 30 © Mimo Monitors
Link Device Connection to Other Connection to
Using unique VLAN in-room PC Devices Corporate Network
0-4094 (no or different VLAN) as needed
Network Setup
For this example, a direct connection between the Myst display and the corporate network is
assumed, but the described concept used on the Link can be utilized on the Connect Myst display
to corporate network and program that port via the smart switch, on a port basis to only support one
VLAN ID (for this example, VLAN 1000). Connect the Link to the Ethernet port on the smaller in-
room switch, and program port 1 to VLAN 1000). The other ports may or may not use VLANs as
utilized within the corporate IT system. Up to 16 pairs of Myst/Link devices may share VLAN 1000
before a different VLAN must be used. that are connected to the corporate network. This isolates
network traffic between the Link and the Myst display.
Proceed with setup similar to “Basic Concept”
with the following exceptions
-
Link Step 5: Configure the Link’s DIP switch to match the Myst’s DIP switch. The setting
matters, and only 16 Myst/Link pairs are allowed per VLAN
- Myst Step 4:
The Myst does not require connecting a power adapter as power is supplied
over PoE from the switch. Be sure that the switch used is capable of powering 802.3af from
each port connected to the Myst display.