MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 106 / 218

- 2.52 -
The fabric cannot be peeled off properly from the belt
Fabric with dense silk texture and organdy may cause slip on the surface of the peeling roller. If the
printing rate is high and ink penetrates to the reverse side of the fabric, the reverse side may be
stained.
In this case, wind the supplied emery cloth #150 in a spiral configuration around the surface of the
peeling roller and then fix both edges with an adhesive tape before printing.
• If emery cloth #150 is wound around the peeling roller, some types of fabric
may be caught, resulting in damage to the reverse side. Check the type of
the fabric in advance.
Taping
Emery cloth