MIMAKI SWJ-320 S2, Maintenance Manual

Page: 95 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.24 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > Temperature control Upper limit value setting
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.
4.2.24 Temperature control Upper limit value setting
 Outline
Setting the upper limit value of temperature control when shipped, to the upper limit value of this machine.
Upper limit value: 70°C (applied to the Post-, Pre- and Print heater)
 Setting procedure
1. Turn the power ON.
2. Shift in the setting mode by pressing [SET] and [<] for more
than 3 seconds simultaneously.
3. Set “0000” to “0001” by pressing [^].
4. Press [SET].
5. Set it to “0070” (Upper limit temperature) by pressing [^], [v]
and [<].
6. Press [SET].
7. End the setting mode by pressing [SET] and [<] for 3 seconds
simultaneously.
 Checking of setting
1. Check that the initial indication is “70” (at shipment: 400) by
switching the power switch of heater from "OFF" to “ON”.
Control key
Set temperature
Current temperature
2 4
5 0
PV
Power ON
SV
C o d
0 0 0 0
PV
[SET] and [<] simultaneously pressing (more than 3 sec)
SV
C o d
0 0 0 1
PV
SV
S L H
0 4 0 0
PV
SV
S L H
0 0 7 0
PV
SV
S L L
0 0 0 0
PV
SV
2 4
5 0
PV
SV
0 0
7 0
Power ON
PV
SV