MIMAKI SWJ-320 S2, Maintenance Manual

Page: 84 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.18 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > FEED COMP.2
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.
4.2.18 FEED COMP.2
 Function
 DECENTERING procedure
1. Set a media at the center of printer.
2. Select [#ADJUST] -> [FEED COMP 2].
3. Select [DECEBTERING], and press [ENTER].
4. Draw an adjustment pattern.
[ENTER] : Executes drawing.
[

] : To the screen for adjustment (Without
drawing)
[END] : Completes drawing and inputs compensation
value.
Item Outline
DECENTERING Compensating the eccentricity of feed roller.
Outputting 16 patterns, and checking/adjusting each pattern.
FEED COMP Compensates basic feeding amount of media. (Provides a baseline value for user compensation value.)
Adjust this when the parameter is initialized.
 By this adjustment, the user compensation value is cleared.
Pattern0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
DECENTERING pattern FEED COMP pattern
<LOCAL>
WIDTH:1000mm
MEDIA SET
MEDIA RESET
[ENT]
FUNCTION
#ADJUST
[ENT]
#ADJUST
FEED COMP 2
[ENT]
When the media is
changed, re-set the width
of media and the height of
head in [MEDIA SET].
FEED COMP
#FEED COMP 2
DECENTERING
[ENT]
 Perform this adjustment in the state that the
media touches to a floor by slackening the front
and back of media.
 When the media is changed, re-set the width of
media and the height of head.
 For the media width, specified as the whole area
of print, check/adjust at the center and both
ends.
 As the adjusting media, use a photo paper.
#DECENTERING
PRINT
[ENT]
Pattern drawing
#DECENTERING
** PRINT **