MIMAKI SWJ-320 S2, Maintenance Manual

Page: 76 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.13 P.1
R.1.2
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > HEAD WASH
Model SWJ-320S Issued 2012.07.19 Revised 2013.03.08 F/W ver 1.0 Remark
1.2
Rev.
4.2.13 HEAD WASH
 Function
Cleans the ink path inside the head, inktank and tube.
When modifying ink type or ink set, empties the ink out of the path and cleans the inside using the washing liquid.
 Work Procedures
1. Remove the following covers.
•Right maintenance cover U
•Right maintenance cover C
•Head cover
•Rear cover LU
2. Select [#ADJUST] -> [HEAD WASH], and press [ENTER]
key.
3. Clean the wiper. Press [ENTER] key after completing to clean.
[ENTER]: To next
4. Set the wash bottle, and press the [ENTER] key.
When washing can not be completed, below message is dis-
played on the screen.
R
e
t
r
y
5. Check the sub-tank state, and select the key.
[

]:Retry washing
[

]:To next
FUNCTION
#ADJUST
[ENT]
#ADJUST
HEAD WASH
[ENT]
WIPER CLEANING
COMPLETED
[ENT]
SET WASH BOTTLE
COMPLETED
[ENT]
WASHING
PLEASE WAIT
 You must set all channels to cleaning bottles.
 Set so that the tips of the ink bottle pipes come
into contact with the bottom of the bottles.
[

]: Go to “LOCAL”
[

]: Resume washing
• Check the position of the sub-tank sensor, leak from the
cap, performance of the suction pump.
•
[

]: Go to “LOCAL”
[

]: Resume washing
• Check the position of the sub-tank sensor, performance of
the ink supply pump.
ERR(DISCHARGE) :MCYK
END < > RETRY
ERR(SUPPLY) :MCYK
END < > RETRY
CHECK SUBTANK
RETRY < > NEXT