MIMAKI SWJ-320 S2, Maintenance Manual

Page: 53 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.2 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] Carriage base tilting
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 2.20 Remark
1.0
Rev.
4.2.2 [HEAD ADJUST] Carriage base tilting
 Outline
For the tilt adjustment procedure using the head adjustment jig of this machine, the adjustment is carried out in the
manner that it moves the front side of head unit left and right, pushing the back side of head unit to the contact end
surface.
The head unit itself has been so adjusted that no tilting occurs if the head unit is mounted, pushing the unit to the con-
tact end surface.
Therefore, at shipped, it is in the condition that the right side of head unit is pressed to the contact end surface.
The head unit is possible to tilt in the right direction but not possible in the left direction since it is in the condition
that the head unit is pressed to the right side.
This adjustment is performed when the head unit is required to be tilted in the left direction due to the accuracy vari-
ation of head unit.
The tilting of all head units are adjustable by tilting the carriage base to the left so that the head unit comes in straight,
referring to the head unit most slanting to the right.
Head
unit
Contact end
surface
Head
unit
Head
unit
Head
unit
Tilted to the left
Tilted to the right
Not possible to tilt in the
left direction
Possible to tilt in the
right direction
Tilting more than acceptable
range to right
Tilt Carriage base, to straighten
Head most slanting to right.
Check/Adjust tilt of each head
unit
After this adjustment, check the tilting, the stagger and the front and back position of all heads,
and execute each adjustment if required.