MIMAKI SWJ-320 S2, Maintenance Manual

Page: 46 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.1.1 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Operation Matrix > For Head adjustment jig
Model SWJ-320S Issued 2012.07.19 Revised F/W ver Remark
1.0
Rev.
4.1.1 For Head adjustment jig
 Outline
As for the head adjustment of SWJ-320S, the dedicated head adjustment jig is established.
The jig is for a service engineer, and does not belong to the machine body.
For the quantity of jig to be used, the number of jigs same as the number of heads is desirable to be prepared.
 Part name and function
Function list
The amount of movement per one screw rotation:
Approx. 500 µm (as a standard)
 Head adjustment jig attachment procedure
1. Store the tip of adjustment bar into the main body by rotating
the tilt adjustment screw and the forward/backward position
adjustment screw counterclockwise.
2. Attach the head adjustment jig to the head.
Tilt adjust-
ment bar
Tilt adjustment
screw
Forward/back-
ward position
adjustment bar
Forward/backward
position adjust-
ment screw
Name
Rotating
direction
Function
Forward/backward
position adjustment bar
Clockwise
The adjustment bar protrudes in
the Y-direction.
Tilt adjustment screw Clockwise
The adjustment bar protrudes in
the X-direction.
This adjustment jig is shared with TS500.
Retract the adjustment bars Retract the adjustment bars
Retract the adjustment bars
Positioning nub
Attach the jig in this
direction
Rear of adjustment jig
Near side of head
Insert the positioning nub
located on the rear of the
head adjustment jig into
this hole