MIMAKI SWJ-320 S2, Maintenance Manual

Page: 196 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 7.2.2 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Troubleshooting > Detailed Methods of Coping with the Malfunctions > Checking of the cap leak
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.
7.2.2 Checking of the cap leak
 Outline
Check whether airtightness of the cap is enough when nozzle missing occurs due to ink suction defect.
 Work procedures
 How to see if suction defect occurs
1. Check that piping between the cap and the suction pump is surely connected.
2. Turn ON the power supply, and make the status capped.
3. Remove the top edge of the tube between the suction pump and the waste tank, and connect the syringe.
4. Pull out the connected syringe slowly. As a reference, pull out about one scale per one second.
(If you pull out it swiftly, you cannot check leakage.)
 Criteria for judgment
OK: If you feel a good response when pulling the syringe (You can feel that you are pulled back.)
The cap is OK. Check other supply system.
NG: If you do not feel a good response when pulling the syringe (You can pull easily.)
Cap leakage occurs. Check the cap and the cap position.
 Do not push the syringe. It may push foreign object into the nozzle, and it may cause nozzle defect.
Suction pump
Tube between cap and suc-
tion pump
Syringe
Tube between suction pump
and waste tank