16
Broken tube
If the ink near-end / ink end occurs despite the remaining amount in 2L ink pack, the tube may have been broken.
In this case, please call for service because the tube replacement is required.
Notes when not using middle cartridge
When you do not use the middle cartridge, thoroughly pull out it from the slot.
Store the middle cartridge you pulled out with its rubber cap pushed into the top edge of it to prevent ink leakage.
1. Thoroughly pull out the middle cartridge.
2. Remove the rubber cap located on the IC chip side of the middle
cartridge.
3. Push the rubber cap into the top edge of the middle cartridge to
prevent ink leakage.
The number of pulling out and inserting the
intermediate cartridge shall be minimized. If you
pull out and insert the middle cartridge again and
again, it may cause ink leakage etc.
Do not pull out further than the stoppers when
pulling out the middle cartridge. Doing so will break
the tube (less than 30 cm) and result in an ink
discharge fault.
Broken tube
Broken tube
Rubber cap
Push into
