MIMAKI JV300-130 A, Installation Manual

Page: 51 / 60

© 2014 MIMAKI ENGINEERING CO.,LTD. 7.3 P.10
R.1.0
1
2
3
4
5
6
7
INSTALLATION GUIDE > Outputting Plots > Cleaning the Heads
Model
JV300
Issue
2014.04.11
Revised F/W ver. 1.00 Remark
1.0
Rev.
7.3 Cleaning the Heads
 Outline
There are three kinds of head cleaning. The type to use depends on the results of the test plot (7.2 (p.8)) .
 Work procedures
1. Press the [FUNC2] key in local mode.
2. Select [CLEANING] and press the [

] key.
3. Press [

] [

] and select the cleaning type.
4. Select the head to be cleaned.
5. Press the [ENTER] key.
• The remaining cleaning time is displayed in the bottom level
of the display.
• When the cleaning finishes, the printer returns to local.
6. Execute the test plot again and check the results.
• Repeatedly perform cleaning and test plot until the test plot
result is normal.
Normal When there are gaps in lines
Soft When you only want to execute a head wipe (when lines are bent)
Hard When the print quality does not improve even after performing normal cleaning
LOCAL
1590mm
Heater///
Ink///
MENU
TEST PRINT/
CLEANING
REMOTE
TEST PRINT >
CLEANING >
STATION MAINTENANCE >
CLEANING
SOFT
>
NORMAL >
HARD >
CLEANING
☑
HEAD 1
☑
HEAD 2
CLEANING
Please Wait…
00:00
Execute the following settings after performing head cleaning.
•
Feed Correction (Operation Manual)
•
Dot position adjustment (7.4 (p.11)) , (7.5 (p.14))