41
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Troubleshooting
• Other information is in FAQ folder in CD-ROM. Please open FAQ.htm with
your browser.
For more information on the troubles, browse the FAQ.htm in the CD-ROM.
The layout area displayed is thinner than the normal size.
When using a roll sheet, the plotter does not detect the sheet length.
Therefore, the displayed layout area is the default value entered in Default Sheet Size in
the Plotter/User Setup dialog. Decrease the value of Default Sheet Size. (see page 33)
Cannot change the sheet size.
When the MGL-IIc commands are used, the sheet size remains unchanged even if
shifting the origin on the plotter and click Load Sheet Size button. In this case, the
sheet size set in the plotter is always displayed. Even if the data fits into the cutting
area in the layout area, the data may cut overflowed.
When the MGL-Ic commands are used, the effective cutting area is displayed. There-
fore, even if shifting the origin on the plotter, it can be cut normally so long as the data
fits into the cutting area.
