MIMAKI Electric slicers, Care Manual

Page: 3 / 8

3
Metal paper guide
If cut media waste and dust adhered between metal paper guide and platen, can not perform media feeding
and printing normally. Clean this place often.
Metal paper guide Metal paper guide with dust
Media sensor
( Operation manual Chapter3 “Cleaning the media sensor”)
In case dust and ink adhered to the media sensor, it causes detecting on error. Wipe out dust and ink with a
soft cloth.
Y main shaft
When Y main shaft is dirty or slider does not move smoothly, apply Y main shaft oil (SPC-0364).
Before apply the oil, wipe out the dust on the Y main shaft with a soft cloth. We recommended cleaning and
applying oil once a month.
Platen
( Operation manual Chapter3 “Cleaning the platen”)
Dust and paper powder easily adhered to the platen. Clean it frequently.
Wipe a platen and its cover with a soft brush or a dried cloth. When cleaning a platen, clean well the groove
for a media paper guide and the one for media cut (cutter line) etc where easily accumulate the dust.
Outer case
( Operation manual Chapter3 “Maintenance for frame components”)
According to the working environment, the dust and cloud of dust may be adhered. Wring a soft cloth firmly
after wetting it with water and wipe out the dust to prevent the head moving part from dust.
Waste ink tank
( Operation manual Chapter3 “When the waste ink tank become full”))
Check the waste ink tank level to prevent overflow.